Publicité
FRONT BRAKE PAD INSPECTION AND REPLACEMENT
Å
REAR BRAKE ADJUSTMENT/
ı
EC364002
REAR BRAKE ADJUSTMENT
1. Check:
Brake pedal height a
Out of specification → Adjust.
Brake pedal height a:
5 mm (0.20 in)
2. Adjust:
Brake pedal height
Pedal height adjustment steps:
Loosen the locknut 1.
Turn the adjusting nut 2 until the pedal
height a is within specified height.
Tighten the locknut.
WARNING
Adjust the pedal height between the
maximum Å and the minimum ı as
shown. (In this adjustment the bolt 3
end b should protrude out of the lower
adjusting nut 4 but not be less than
2 mm (0.08 in) c away from the brake
pedal 5).
After the pedal height adjustment, make
sure that the rear brake does not drag.
EC365080
FRONT BRAKE PAD INSPECTION AND
REPLACEMENT
1. Inspect:
Brake pad thickness a
Out of specification → Replace as a
set.
Brake pad thickness a:
Standard
4.4 mm
(0.17 in)
2. Replace:
Brake pad
Brake pad replacement steps:
Remove the pad pin plug 1.
3 - 28
INSP
ADJ
<Limit>
1.0 mm
(0.04 in)
Publicité
