Wacker Neuson 803 Notice D'utilisation page 86

Operation
3.10 Lowerable ROPS rollbar (up to serial no. AI00966) (option)
P
C
A
Fig. 85: Lowerable ROPS rollbar (option)
Lowering the rollbar
3-32
Warning! WARNING
Accident hazard when operating the machine with a lowered
rollbar!
Can cause serious injury or death.
• Machine operation is only allowed if the rollbar is raised and locked, and if
• Depending on the situation, traveling over very short distances with a low-
Warning! WARNING
Injury hazard due to unfastened seat belt!
Can cause serious injury or death.
• Use the seat belt only if the rollbar is raised!
Warning! WARNING
Injury hazard due to damaged rollbar!
Can cause serious injury or death.
B
• Machine operation with a damaged rollbar is prohibited. Contact a Wacker
S
NOTICE
D
The boom must not be moved if the rollbar is lowered!
Bracket P for installing a rotating beacon is located on top of the rollbar.
Stop the machine on firm, level and horizontal ground
Stop the engine
Raise the lock lever
Remove the starting key
Information!
In order to lower it, the rollbar must be held by one person on either side.
Remove the lock nuts and screws A on either side
Slowly and carefully lower the rollbar
Insert the screws again on either side and secure them with the lock nuts
the seat belt is fastened.
ered rollbar is allowed (in case of low clearance heights, for example)
chapter Operation with lowered ROPS rollbar on page 2-9.
Neuson service center.
– see
OM 803 us – Edition 3.7 * * 803b330.fm