Wacker Neuson 803 Notice D'utilisation page 210

Quick-coupling Device Safety
Before using a quick-coupling device you must know and
understand proper installation, maintenance and operation.
WARNING! Failure to read and follow manufacturer's
instructions for the correct operation and mainte-
nance of the quick-coupler can allow the attachment
to come off and cause death or serious injury.
Protect yourself from injury:
— Install and maintain equipment, attachments and their
operating systems according to manufacturers'
instructions.
— Securely latch attachments before work begins.
— Follow the manufacturer's instructions for using
positive locks on quick-coupling equipment.
— Make frequent visual inspections of quick-coupling
systems—especially after changing attachments.
— Always check for interference limits of the coupler or
tool with the carrier before operating.
Do not operate the machine if:
— there exists an incompatibility among components.
— there are broken, damaged or badly worn components.
— the lock/secure feature of the quick-coupler is impaired.
— the engaging lever or device is not fully engaged in
a lock/secure condition.
Clean Up
Clean windshields, mirrors and all lights. Use water and
a clean cloth. Know and follow the manufacturer's
recommendations for using cleaning agents other than
clean water on polycarbonate glazing.
Clean out the operator's area. Steps and handholds
must be clean and functional. Oil, grass, leaves,
needles, snow, ice or mud in these areas can cause you
to slip and fall.
Clean your boots before getting on the machine.
Clean out trash and debris buildup promptly, especially
in the engine compartment, the battery box, around
exhaust components, under the machine and around
rotating components.
Remove all loose personal items or other objects from
the operator's compartment. Secure these items in a
fixed tool box or remove them from the machine. Do not
store any flammable material such as ether/cold-start
fluid or oily rags in the operator's compartment.
18
Prepare For Safe Operation
Prepare For Safe Operation
WARNING! A quick-coupler that is not properly
locked/secured could result in death or serious injury.
Perform all steps to lock/secure the device. The
steps to confirm that the device is properly
locked/secured may include any or all of the following:
— Manually installing a locking pin, actuating a lever or
other device.
— Movement of the attached work tool to confirm its
engaged lock/secure condition.
— A visual check of the components as instructed by
the quick-coupler manufacturer.
WARNING! A quick-coupler that is disengaged when
the attachment is in an unstable position could result in
death or serious injury. Place the attachment in a
stable position, as instructed by the manufacturer,
whenever coupling or uncoupling the attachment.
Read And
Understand
Manuals Before
Operating
Maintain Vision –
Clean Up
Avoid Falls –
Clean Slippery
Surfaces
Avoid Fire –
Clean Out Debris
Put Away Tools
And Loose Items
17