Wacker Neuson 803 Notice D'utilisation page 213

Know the exact starting procedures for this machine.
See the manufacturer's manual(s) for starting
procedures.
— Clear the area of all persons.
— Sit in the operator's seat and adjust the seat so you
can operate all the controls properly.
— Familiarize yourself with warning devices, gauges and
operating controls.
— Close or secure the cab door, if equipped.
— Fasten the seat belt, if equipped. If the compact
excavator is equipped with a foldable TOPS/ROPS,
do not fasten the seat belt when the TOPS/ROPS is
in the down position.
— Put all controls, including those for auxiliary
equipment, in the neutral/park position.
— Activate controls by releasing the control lock, if
equipped.
— Start the engine following the instructions in the
manufacturer's manual(s).
If it is necessary to run the engine or operate the
machine within an enclosed area, be sure there is
adequate ventilation.
Starting Aids
Do not use ether/cold-start fluid if the engine is equipped
with glow plugs or intake manifold preheater.
Ether/cold-start fluid is HIGHLY FLAMMABLE.
Before using it, always read the instructions on the
ether/cold-start fluid container and the instructions in
the manufacturer's manual(s). Do not carry loose cans
of starting fluid on the machine while operating.
If booster cables are used, follow the instructions in the
manufacturer's manual(s). The operator must be in the
operator's seat when boost-starting the engine so that
the machine will be under control when the engine
starts. Boost-starting is a two-person operation.
A battery explosion or a run-away machine could result
from improper starting procedures.
Never boost-start a frozen battery. (See page 48, Avoid
Battery Explosion.)
After Starting The Engine
Observe gauges, instruments, and warning lights to
ensure that they are functioning and their readings are
within the operating range.
24
Start Safely
WARNING! Never operate any type of engine without
proper ventilation—exhaust fumes can kill.
Start Safely
With the control levers or joysticks in neutral, test engine
speed control.
Run An Operating Check
Do not use a machine that is not in proper operating
condition. It is the operator's responsibility to check
the condition of all systems, and to run the check in a
safe area.
WARNING! Do not allow anyone to stand within the
operating work radius of the machine and load.
Contact with moving parts of the compact excavator or
load can cause death or serious injury.
Know Starting
Procedure,
Read Manual
Fasten Seat Belt,
Use TOPS/ROPS
Ventilate
Work Area
Keep
Bystanders
Away
23