Wacker Neuson 803 Notice D'utilisation page 169

Instructions concerning specific components
Alternator
OM 803 us – Edition 3.7 * 803b530.fm
Cables, lamps and fuses
Always observe the following instructions:
• Malfunctioning components of the electrical system must always be replaced by a Wacker
Neuson service center. Lamps and fuses may be replaced by unqualified persons.
• When performing maintenance on the electrical system, pay particular attention to
ensuring good contact in leads and fuses.
• Blown fuses indicate overloading or short circuits. The electrical system must therefore
be checked before installing a new fuse.
• Only use fuses with the specified load capacity (amperage)
– see chapter Fuses behind the right-hand trim on page 6-4
Observe the following instructions:
• Start the engine only if the battery is connected
• When connecting the battery, ensure that the poles (+/−) are not inverted
• Always disconnect the battery before performing welding work or connecting a quick
battery charger!
• Have malfunctioning charge indicator lights immediately replaced
Indicator light (red) – alternator charge function on page 3-11
Maintenance
– see chapter
5-29