Wacker Neuson 803 Notice D'utilisation page 39

Mechanical integrity
Traveling
OM 803 us – Edition 3.7 * 803b210us.fm
• Take the necessary precautions to make sure the machine is used only when in a safe
and serviceable state.
• Operate the machine ONLY if all protective and safety-oriented devices (ROPS,
removable safety-devices, soundproofing elements, mufflers, etc.) are in place and fully
functional.
• Check the machine before entering the cab to operate the machine for visible damage
and defects. Report any changes, including changes in the machine's function and
response, to your supervisor immediately.
• If the machine is functioning unpredictably or in event of malfunctions, stop the machine
immediately, lock it, and report the malfunction to a qualified technician or supervisor.
Safety-relevant damage or malfunctions of the machine must be rectified immediately.
• Before moving the machine always check whether the supplementary equipment and
the attachments have been safely stowed away or attached.
• Careful when reversing the machine – accident hazard.
• Persons in the blind spot of the machine cannot be seen by the operator.
• Ensure that nobody is within the danger zone of the machine when changing the
traveling direction.
• Use the rearview mirrors to reverse with the machine.
• When traveling on or in public areas, observe all applicable regulations. Make sure
beforehand that the machine is in compliance with these regulations.
• Installed work lights must NOT be used for travel.
• When crossing underpasses, gates, bridges and tunnels, or when passing under
overhead lines, make sure the clearance height and width are sufficient to avoid
contact.
• Empty the bucket and tilt it in until the bucket opening is in the upward horizontal
position as a minimum before traveling on public roads.
• Apart from the operator, no other persons are allowed to ride on the machine.operator
Safety instructions
2-7