Publicité
Les langues disponibles
Les langues disponibles
A hand start
1. Turn the tank ventilation valve Fig. 6-2
2. Open the fuel valve by turning the rotary knob
3. Pull the choke lever
4. Move the engine start switch
5. Support yourself with one hand or a foot on the device and pull strongly on
6. Do not just release the grab handle
7. Push the choke lever
NOTICE!
Do not apply load to the generator immediately after a cold start.
► Allow the generator engine to warm up for a few minutes before switching on
7.4
Proceed as follows to switch off your generator:
Requirements
the attached power consuming equipment is disconnected or switched off.
Certain surfaces on the device can get very hot whilst it is running.
Risk of burns
► Never touch any engine parts (in particular the exhaust system) for a few min-
► Always leave hot engine parts to cool down before touching them.
Switching the gen-
1. Continue to run the engine without load for about two minutes.
erator off
2. Move the engine start switch Fig. 7-3 -
3. Turn the rotary knob on the fuel valve Fig. 7-3 -
The generator is switched off and secured.
cover.
fully for a cold engine, somewhat less for a hot en-
gine.
the grab handle
of the cable pull starter/
The engine starts.
the generator.
The green operation indicator light
back in again slowly. If the engine begins to run un-
evenly, pull out the choke lever out a little
process.
The motor runs at a stable speed.
You can connect to one piece of power consuming equipment.
You can use ECO mode (see Chapter 8.2 .
a load when the generator has not been operating for more than eight hours
(or for very low external temperatures).
Turning off your power generator
CAUTION!
utes after ceasing operation.
The engine comes to a standstill and the generator is switched off.
to the position "ON" on the tank
into the "I" position.
into the "I" position.
but instead lead it carefully back into
lights up.
for a short time and repeat the
into position "0".
back into position "0".
Commissioning
EN
33
Publicité
