Endress ESE 3000 i Traduction De La Notice Originale page 102

Maintenance
EN
Item
Exhaust system
Carburettor
Cable pull starter
Fastening and thread-
ed joints
40
Maintenance work
Maintenance step
Check for leaktightness, fas-
ten, if necessary, change seals
Check the spark screen, clean;
change when necessary
Check the choke function
Check the cable pull and func-
tion
Check for a fixed hold and
damage; replace if necessary
Maintenance work should be performed by your service partner.
9.2 Maintenance work
Only authorised specialist personnel are allowed to carry out maintenance
tasks. Execute all of the maintenance steps in the maintenance schedule
according to the following instructions.
CAUTION!
Certain surfaces on the device can get very hot whilst it is running.
Risk of burns
► Never touch any engine parts (in particular the exhaust system) for a few min-
utes after ceasing operation.
► Always leave hot engine parts to cool down before touching them.
NOTICE!
Also always read about the checking and maintenance work which con-
cerns the electrical safety of the generators in the chapter "Checking the
electrical safety".
Disconnect the negative pole of the starter battery in order prevent unin-
tentional restarting of the engine whilst working on it (see Chapter 9.6.2).
Maintenance interval according to time
or operating hours [h]
Every 8 every 3
h /daily months
or 25h
X
X
X
Tab. 9-1 Generator maintenance plan
every 6 annual-
months ly every
or 50h 100 h
X
X