Endress ESE 3000 i Traduction De La Notice Originale page 109

Remove spark plug 1. Loosen the four screws on the maintenance flap Fig. 6-3
2. Pull the spark plug connector Fig. 9-7 -
3. Place the spark plug wrench on the spark plug Fig. 9-7 -
The spark plug is removed and must now be assessed.
Checking the spark 1. Check the spark plug for damage and clean it using a suitable brush, if it can
plug
2. Check the condition and gap of the electrodes, also when using a new spark
The spark plug is ready to be installed.
1
1
Fig. 9-7 Remove spark plug
maintenance flap.
pull directly on the plug, never on the ignition cable!
by turning anti-clockwise.
Fig. 9-8 Checking the spark plug
be used again.
plug. Adjust the gap to the correct value if necessary (see Fig.Fig. 9-8 ).
Maintenance
2
and remove the
of the spark plug. To do this always
and loosen this
EN
47