Publicité
Les langues disponibles
Les langues disponibles
Safety symbols
These warning notices are usually used in a safety symbol which also emphasis-
es the type of danger; see next example. A list of the safety symbols used in this
operating manual can be found in Chapter Fig. 3-1 . The safety symbols never
stand alone.
Notices on avoidance of damage to the device
According to DIN ISO 3864, notices which warn against false operation and pos-
sible damage to the device or to the equipment used should be clearly distin-
guishable from previously named warning notices in as far there is no danger to
health. An example of such a notice can be seen here:
NOTICE!
Use of wrong or outdated fuel damages or destroys the engine.
► Only use released fuel.
► Observe the shelf life of the fuel according to the supplier.
► Observe the Operating manual from the engine manufacturer
Symbols and formattings in the text
In order to increase the legibility, comprehensibility and transparency of the doc-
ument, various information and activities are awarded uniformly repeating bullets
or formattings. The following example shows presentation of a sequence of ac-
tions with established work steps:
Example:
Prerequisites which must be fulfilled before starting any sequence of actions
1. Action steps according to a fixed sequence.
2. The action steps must be fully completed.
3. The sequence must be observed.
Results of the action which should be achieved after performing the sequence of
action.
Additional notices for operation or for function of a unit are marked with the
adjacent symbol.
NOTICE!
The adjacent symbol is situated anywhere where the supplier documenta-
tion must be read and observed and refers to,
► appropriate information,
► tasks or
► action steps.
References to details and components in figures are made with blue bordered
position numbers in the text such as the example of CE signs on the type plate
demonstrates, see Fig. 3-1 .
About this manual
EN
7
Publicité
