Endress ESE 3000 i Traduction De La Notice Originale page 111

6. Install the starter battery again in the generator (see Chapter 9.6.2 ).
The starter battery is charged.
If the generator cannot be started after fully charging the battery, there is a defect
in the starter power circuit of the generator. Contact your service partner.
NOTICE!
The starter battery from the factory is maintenance-free throughout its en-
tire service life.
► Never try to open the battery - risk of destruction.
9.6.2
Proceed as follows to change the starter battery.
Requirements  The generator is turned off.
Remove the starter 1. Loosen the six screws to remove the ventilation grille Fig. 6-2
battery
2. Remove the retaining strap Fig. 9-9 -
3. Remove the cover Fig. 9-9 -
4. Carefully pull the starter battery out of its compartment to expose the battery
5. FIRST loosen the black cable Fig. 9-9 -
6. LATER loosen the red cable Fig. 9-9 -
7. Pull the red pole protection cap off the positive pole of the battery and THEN
8. Fully remove the battery from the battery compartment.
9. Loosen the six screws to remove the ventilation grille Fig. 6-2
The starter battery is removed.
Replacing the battery
You now have access to the starter battery under the cover Fig. 9-9 -
connections.
tery.
loosen the red cable from the battery.
Fig. 9-9 Replacing the starter battery
.
from the battery.
from the negative pole of the bat-
from the positive pole of the battery.
Maintenance
EN
.
.
.
49