Endress ESE 3000 i Traduction De La Notice Originale page 112

Maintenance
EN
Installing the start-
er battery
One has the re-
quired tool
Requirements
Servicing the spark
screen
50
1. Make ready a new starter battery (Observe the instructions from the battery
manufacturer.
2. FIRST fasten the red cable Fig. 9-9 -
3. THEN fasten the black cable Fig. 9-9 -
4. Place the starter battery in the battery compartment.
5. Put the cover Fig. 9-9 -
6. Fasten the battery with the retaining strap Fig. 9-9 -
7.
The starter battery has been replaced. The generator can now be started.
9.7 Cleaning the spark screen
The spark screen prevents escaping of glowing exhaust particles and is lo-
cated right next to the exhaust outlet. It must be disassembled every 100
operating hours and cleaned. The spark screen must be replaced if it is
strongly soiled or damaged.
Proceed as follows to service the spark screen.
• a small slotted-head screwdriver
• Wire brush
 The generator is switched off.
 The engine and particularly the exhaust system have cooled down.
1. Loosen both screws Fig. 9-10 -
2. Remove the fixing plate Fig. 9-10 -
3. Loosen the spark screen with the aid of a small slotted-head screwdriver Fig.
9-10 - from the exhaust gas outlet and pull it out completely.
The spark screen is removed.
4. Assess the condition of the spark screen and replace it if it is damaged.
to the positive pole of the battery.
to the negative pole of the battery.
over the battery.
Fig. 9-10 Spark screen
on the spark screen.
on the spark screen.
.