Endress ESE 3000 i Traduction De La Notice Originale page 107

Change the air filter 1. Loosen the six screws to remove the ventilation grille Fig. 6-2
insert
2. Open both fastening clamps Fig. 9-6 -
3. Remove the air filter insert Fig. 9-6 -
4. Clean the air filter housing and cover, in this case in particular the suction
5. Protect your hands from contact with engine oil.
6. Apply a few drops of new engine oil to the cleaned or new air filter insert.
7. Knead the air filter insert in order to distribute the oil evenly into the foam.
8. Wring out the air filter insert strongly afterwards to remove excessive oil.
9. Insert the air filter insert into the air filter housing.
10. Carefully place the air filter cover
11. Insert the ventilation grille Fig. 6-2
12. Dispose of a soiled air filter insert according to regulations.
Maintenance of the air filter is complete.
Fig. 9-5 Air filter behind the ventilation grille (removed)
the air filter housing Fig. 9-5
9-6 .
a) in a case of minor soiling remove loose dirt particles from the air filter in-
sert.
b) in a case of strong soiling use a new air filter insert.
opening.
using the clamps .
accessible.
and pull off the air filter cover Fig.
and decide after the assessment:
on the air filter housing and fasten it on
again and fasten using six screws.
Maintenance
EN
and to make
45