Endress ESE 3000 i Traduction De La Notice Originale page 94

Commissioning
EN
Electrical start
32
NOTICE!
Your generators will be delivered without any engine oil in it.
► You must fill the engine with engine oil before using it for the first time as de-
scribed in Chapter 9.3.2 .
1. Turn the tank ventilation valve on the tank cover Fig. 6-2
position.
2. Open the fuel valve by turning the rotary knob
3. Pull the choke lever
gine.
4. Press and hold down the engine start switch
The engine starts.
The green operation indicator light
5. Release the engine start switch
6. Push the choke lever
evenly, pull out the choke lever out a little
process.
The motor runs at a stable speed.
You can connect to one piece of power consuming equipment.
You can use ECO mode (see Chapter 8.2 .
NOTICE!
Only activate the starter briefly (max. 5-10 seconds). Never start or run the
engine with the battery disconnected.
Fig. 7-3 Operating controls for an electrical and a manual start
fully for a cold engine, somewhat less for a hot en-
in position "II".
lights up.
.
back in again slowly. If the engine begins to run un-
for a short time and repeat the
into the "ON"
into the "I" position.