These instructions apply to all the revisions of said equipment, as well as all the accessories that may have been provided, therefore the description of some parts may not correspond to your equipment.

Inspection and preventive maintenance must be performed at scheduled intervals to protect the health and safety of patients, users and other persons in accordance with national regulations regarding the use, maintenance of dental x-ray devices

that are in force in the country where the device is installed.

In order to ensure the operational safety and functional reliability of your product, the system owner should check the equipment at regular intervals (at least once a year) or commission an authorized technician to do so.

If one or more checks to be performed are not satisfactory, please contact your dealer tech support.

Step

Check that all labels located

on the detector/detectors,

on the 3D Panel (if present)

at the base of the column,

on the X-ray tube housing,

are intact, well attached and legible.

Check there are no external damages to the equipment which could reduce protection

against radiation.

Check the remote emission button cable is not broken or scratched.

Check the power switch verifying that the switch is working properly and the touch panel

display illuminates when the switch is in the on position.

Verify that exposure is immediately interrupted when X-rays button is released

Check the touch console functionality: functions must respond to interrogation.

Check proper functioning of X-ray exposure LED and exposure buzzer

Check proper functioning of X-ray cenetring laser traces

Check if detector fits easily in the guides Pan and CEPH sides – only for unit with

Cephalometric arm and one removable detector.

Perform a motors movement test running the Dummy panoramic procedure, making sure

the movement on the 3 axis X, Y,R (rotation and translation simultaneously) is smoothly

and without noise. See figure 1, next page.

In case a Cephalometric arm is installed, perform a motors movement test of the

cephalometric detector using the Dummy Ceph exam procedure, making sure the

movement on the axe H (translation) is smoothly and without noise. See figure 1, next

page.

Perform column movements, up and down on the Z axis and check proper functioning.

See figure 2, next page.

Check the emergency button functionality. Emergency button is used to stop X-ray

device operation, it's located under the patient support arm in proximity of the telescopic

column Emergency button).

Check the X-Ray Generator functionality performing a complete trial exam exposure.

Select any panoramic exam and reset the unit. Hold down the emission button

throughout the entire exam procedure. Absence of error messages assures a proper

generator functionality.

If Quality Phantoms are not available at installation site, then contact your dealer tech support to have the Quality Assurance procedure performed at your premises

Perform an exam on the 3D Quality Phantom and evaluate the quality of the outcome

volumetric study.

The undersigned confirms that the equipment was checked for the above criteria and that, in case of any malfunction, an authorized technician of the local dealer was informed.

All inspection and maintenance work performed by the system owner and/or service engineer must be recorded in this document and kept near the unit!

OPERATOR'S MANUAL

Description

Section Identification label position

Section Description of operations

Section X-ray emission remote control

Section Starting the system

Section X-ray emission remote control

Section Touch screen display

Section X-ray emission remote control

Section Laser traces

Section Sensor positioning

To execute a dummy run, exam simulation without emitting radiation, select any

panoramic exam and reset the unit. Once the reset position is reached, hold down

button "Reset" throughout the entire exam procedure, otherwise movement will stop.

To execute a dummy run, exam simulation without emitting radiation, select any

cephalometric exam and reset the unit. Once the reset position is reached, hold

down button "Reset" throughout the entire exam procedure, otherwise movement will

stop.

Section Control Panel (console onboard the machine)

User Manual, section Emergency button

Section Performing a 2-D X-Ray examination

Acquisition Operations with Annex

Reference in User Manual

Operator Name

Signature

Answer questions with yes (√) or no (−)

Inspection DATE

__/__/20__