5.3.4. EXAMINATION SUMMARY PAGE
This page can be viewed only if the device is ready. This page shows:
-
the various X-ray technique factors correctly set and an icon for the relevant setting mode
(PRESET) or
-
the examination type selected;
-
icons at the bottom of the page with which you can redefine the projections and the anatomic region involved in
the examination.
5.3.5. EDENTOLOUS PATIENTS DEVICES
In case of edentulous patients, for the PAN, DENT, SIN, DTS or CB3D examinations requiring the use of the bite piece,
apply the single-use soft insert supplied, as follows:
1 - remove the soft bite from the mould (Fig. 1);
2 - apply the single-use protection on the bite piece (Fig. 2);
3 - insert the soft bite in the bite piece as indicated in the figure (Fig. 3);
4 - push the bite until the material block is ejected (Fig. 4).
Always apply the single-use protection on the bite piece before inserting the soft bite.
Then proceed to standard positioning for the exam, asking the patient to tighten the mucous membranes at the centre
of the soft insert.
Fig. 1
EN
(CUSTOM);
Fig. 2
OPERATOR'S MANUAL
Fig. 3
(AUTOMATIC),
Fig. 4
33