Publicité
Manuel d'instructions
IB-106-340-F - Rév. 1
Octobre 2004
FOR THE WIRING AND INSTALLATION
The following safety instructions apply specifically to all EU member states. They
should be strictly adhered to in order to assure compliance with the Low Voltage Di-
rective. Non-EU states should also comply with the following unless superseded by
local or National Standards.
1. Adequate earth connections should be made to all earthing points, internal and external, where
provided.
2. After installation or troubleshooting, all safety covers and safety grounds must be replaced. The
integrity of all earth terminals must be maintained at all times.
3. Mains supply cords should comply with the requirements of IEC227 or IEC245.
4. All wiring shall be suitable for use in an ambient temperature of greater than 75°C.
5. All cable glands used should be of such internal dimensions as to provide adequate cable an-
chorage.
6. To ensure safe operation of this equipment, connection to the mains supply should only be made
through a circuit breaker which will disconnect all circuits carrying conductors during a fault si-
tuation. The circuit breaker may also include a mechanically operated isolating switch. If not,
then another means of disconnecting the equipment from the supply must be provided and
clearly marked as such. Circuit breakers or switches must comply with a recognized standard
such as IEC947. All wiring must conform with any local standards.
7. Where equipment or covers are marked with the symbol to the right, hazardous volta-
ges are likely to be present beneath. These covers should only be removed when po-
wer is removed from the equipment — and then only by trained service personnel.
8. Where equipment or covers are marked with the symbol to the right, there is a danger
from hot surfaces beneath. These covers should only be removed by trained service
personnel when power is removed from the equipment. Certain surfaces may remain
hot to the touch.
9. Where equipment or covers are marked with the symbol to the right, refer to the Ope-
rator Manual for instructions.
10. All graphical symbols used in this product are from one or more of the following standards:
EN61010-1, IEC417, and ISO3864.
P-2
Préface
IMPORTANT
SAFETY INSTRUCTIONS
OF THIS APPARATUS
Rosemount Analytical Inc. – Groupe Emerson Process Management
Oxymitter 4000
Publicité
Dépannage
