Viewing And Setting The Delay Before Switching - Burkert 8041 Manuel Utilisateur

Adjustmentandfunctionalities
to confirm the selection and go
back to Read mode
→
Briefly press push button.
Go back to Read mode
.....
Fig. 41 : Setting the relay switching thresholds, part 3

10.9.3. Viewing and setting the delay before switching

Switching occurs if one of the thresholds (low, high) is exceeded for a period longer than the set delay. The delay applies to both switching
thresholds. If the delay is equal to 0, switching occurs immediately.
The delay before switching must be set to between 0 and 100 s.
The delay before switching is set in 2 stages:
- setting the factors of ten for the seconds;
- setting the seconds.
→
Viewing and/or setting the delay before switching (see
Type 8041
to modify the value displayed
→
Press and hold the push
button
→
Release push button when
desired number of LEDs is on
Fig. 42 , Fig. 43 and Fig. 44 ).
c
to go back to Read mode
without confirming the value set.
→
Wait 10 s
Go back to Read mode
.....
English
43