Burkert 8041 Manuel Utilisateur page 46

Notation convention: .....
Status of the red LED
Status of the green LED
Transmitter in Read mode?
.....
YES
to view delay before switching
→
Press push button briefly four times
0 s 100 s
1 2 3 4 5 6 7 8 910
Bar graph shows current delay before switching, 52 s in the
example (by default = 100 s)
to set the factors of ten for the seconds of the delay
before switching
→
Press and hold the push button
After 2 s, transmitter in Settings mode:
Fig. 42 : Setting the delay before relay switching, part 1
44
See general con-
NO
figuration diagram
§ 10.3
A
English
Type 8041
Adjustmentandfunctionalities
If delay before switching set to 52 s, LED no. 6
flashes 9 times then stays on
Next LEDs come on one after the other
→
Release push button when the desired
number of LEDs is on.
1 LED on = 10 s
to set the seconds of the delay before
switching
→
Press and hold the push button
After 2 s, next LED flashes
1 flash = 1 s
→
Release push button when the LED has
flashed the desired number of times
B
Fig. 43 : Setting the delay before relay switching, part 2
A
C D