Set Up With The Indicating And Adjustment Module; Short Description; Insert The Indicating And Adjustment Module - Burkert 8185 Mise En Service

Set up with the indicating and adjustment module

Function/Configuration
Mounting/dismounting the in-
dicating and adjustment
module
18
6 Set up with the indicating and
adjustment module

6.1 Short description

The indicating and adjustment module is used for measured
value indication, adjustment and diagnoses. It can be used in
all sensors of the LEVEL TRANSMITTER family.
From a hardware revision ...- 01 or higher of the indicating and
adjustment module, i.e. the corresponding sensor electronics,
an integrated backlight can be switched on via the adjustment
menu. The hardware revision is stated on the type label of the
indicating and adjustment module or the sensor electronics.
Information:
This function is for instruments with StEx, WHG or ship
approval as well as country-specific approvals such as those
according to FM or CSA, available at a later date.
Note:
You will find detailed information on the adjustment in the
operating instructions manual of the "Indicating and adjustment
module".

6.2 Insert the indicating and adjustment module

The indicating and adjustment module can be inserted into the
sensor and removed again at any time. It is not necessary to
interrupt the power supply.
To mount, proceed as follows:
1 Unscrew the housing cover
2 Place the indicating and adjustment module in the desired
position on the electronics (you can choose any one of four
different positions - each displaced by 90°)
3 Press the indicating and adjustment module onto the
electronics and turn it to the right until it snaps in.
4 Screw housing cover with inspection window tightly back
on
Removal is carried out in reverse order.
The indicating/adjustment module is powered by the sensor,
an additional connection is not necessary.
LEVEL TRANSMITTER 8185 - 4 ... 20 mA/HART