Viewing And Setting The Low And High Switching Thresholds - Burkert 8041 Manuel Utilisateur

to confirm the selection and go back
to Read mode
→
Briefly press push button.
Go back to Read mode
.....
Fig. 38 : Choosing the relay switching mode, part 2

10.9.2. Viewing and setting the low and high switching thresholds

The low switching threshold can be set in the range from 0 to the high switching threshold value.
The high switching threshold can be set in the range from the low switching threshold value to 100% of the full range.
The low and high switching thresholds are set in 2 stages:
- setting the factors of ten;
- setting the units.
→
Viewing and/or setting the low and high switching thresholds (see
40
→
Release push button when bar graph shows
desired mode.
to choose the other mode
→
Press and hold the push button
English
Go back to step 1, Fig. 37
Fig. 39 , Fig. 40 and Fig. 41 ).
Type 8041
Adjustmentandfunctionalities
to go back to Read mode without
confirming the selection
→
Wait 10 s
Go back to Read mode
.....