Electrical Connections; K Factors - Burkert 8041 Manuel Utilisateur

Masquer les pouces Voir aussi pour 8041:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Power source (not
provided)
Current output
Type of output
Refresh time
Max. loop resistance
Frequency output
Frequency
Duty cycle
Max. current
protected against
short circuits and
polarity reversal
Relay output on versions
not approved by UL
12
Source with limited power in
accordance with § 9.3 of the
UL 61010-1 standard second edition
or the EN 61010-1 standard
Or low power source in accordance
with the UL 60950-1 standard
or class 2 source in accordance with
the UL 1310 or UL 1585 standards
4-20 mA, sink or source by wiring
100 ms
W at 36 VDC, 330 W at
1100
18 VDC
0-240 Hz
50 % ± 1 %
100 mA max.
yes
Normally open or normally closed,
depending on the wiring
3 A, 250 VAC max.
English
Type 8041
Technicaldata
Relay output on versions
approved by UL
Alarm
Full scale exceeded
Error signal
6.3.4.

electrical connections

Connection type
Cable data
Cable type
Cross section
Diameter of each cable:
-
if only one cable per cable
gland
-
if two cables in one cable
gland
6.3.5.

K factors

The 8041 transmitter measures the fluid velocity (m/s) and converts it
into a current I (mA) and a frequency f (Hz).
Normally open or normally closed,
depending on the wiring
maximum 30 VAC and 42 V peak or
60 VDC, 2.5 A max.
22 mA and 256 Hz
22 mA and 0 Hz
Via two cable glands M20x1.5
shielded
0,75 mm
2
-
6...12 mm
-
4 mm, with multi-way seal
provided

Publicité

Table des Matières
loading

Table des Matières