Burkert 8041 Manuel Utilisateur page 44

If low switching threshold set to 24%, LED no. 3
flashes 9 times then stays on;
1 flash = 1% of the FS
Next LEDS come on one after the other until they
show the factor of ten for the current high switching
threshold;
1 LED on = 10% of the FS
→
Release the push button when desired number
of LEDs is on.
to set the units for the low switching threshold.
→
Press push button
After 2 s, next LED flashes;
1 flash = 1% of the FS
Fig. 40 : Setting the relay switching thresholds, part 2
42
A
→
Release push button when LED has flashed the desired
number of times
English
Type 8041
Adjustmentandfunctionalities
If high switching threshold set to 82%, LED no. 9
flashes 9 times then stays on;
1 flash = 1% of the FS
Next LEDS come on one after the other until they
show the factor of ten for the current low switching
threshold;
1 LED on = 10% of the FS
→
Release the push button when desired number of
LEDs is on.
to set the units for the high switching threshold.
→
Press push button
After 2 s, next LED flashes;
1 flash = 1% of the FS
C
B