Controlling And Testing The Fuel Shut-Off Valve; Testing The Fuel Pump; Controlling And Testing The Propane Valve - GRAUPNER JetCat P60 Instructions D'utilisation

[Seite 21]

Controlling and testing the fuel shut-off valve

All the time manual mode is active (yellow "Standby" LED flashing), and also when the pump voltage is
anything other than zero, the shut-off valve is automatically opened (-> see above).

Testing the fuel pump

1. Set the 3-position switch on the transmitter to OFF.
2. Move the throttle trim to ON (= forward) and set the throttle stick to idle.
3. Activate manual mode -> Manual button (-> yellow LED flashes).
4. Set the Aux switch to the centre position to start the fuel pump. You can now directly control the pump
voltage with the throttle stick. To stop the fuel pump: move the throttle trim to OFF and pull the throttle
stick back, or set the Aux switch to OFF (-> terminate manual mode).
5. Finally: disable manual mode again -> Manual button, or set the 3-position switch to OFF (-> yellow LED
no longer flashes).
Before you test the fuel pump, do not forget to disconnect the fuel feed line to the turbine, otherwise the
engine will be flooded with fuel.

Controlling and testing the propane valve

1. Switch off the electronics
2. Press and hold the "Min/Max" button
3. Switch on the electronics
4. Release the Min/Max button as soon as the message "GasValve Test" appears on the screen.
5. Press the "Min/Max" button to test (open) the valve.
6. To terminate the test press the "Manual" button, or switch off the electronics.
20