Maintenance; Accessories (Hoses / Connectors) - GRAUPNER JetCat P60 Instructions D'utilisation

[Seite 45]

Maintenance

A build-up of dust and oil deposits on the compressor nut may cause the starter unit coupling to slip, or fail to
engage properly. If this should happen, you can eliminate the problem by cleaning and de-greasing the
compressor nut (e.g. using cellulose thinners or similar solvent on a paintbrush). You can check that the
starter unit is working properly when the turbine is in the "OFF" state by pressing the "IGNITION" button.
The maintenance interval of the turbine is around 50 hours. When the engine has completed this period of
running, it should be sent to the factory for checking, complete with the control electronics. The total run time
of the turbine can be read off in the "STATISTIC" menu.
Accessories
Order No. 6800.1
Order No. 6800.2
Order No. 6800.3
Order No. 6800.5
Order No. 6800.6
Order No. 6800.7
Order No. 6800.8
Order No. 6800.9
Order No. 6800.10
Order No. 6800.11
Order No. 6800.12
Order No. 6800.13
Order No. 6800.14
Order No. 6800.15
Order No. 6800.16
Order No. 6800.17
Order No. 6800.200
Order No. 6800.203
Order No. 6802
Order No. 6803
Order No. 2650
Any liability for printing errors excluded. Subject to technical modifications.
Quick-release hose connector 4 -> 4
Quick-release hose connector 4 -> 3
Quick-release hose connector M5 -> 4 mm with M5 grommet
Special fueltank clunk pick-up
Hose set
Hose closure complete, 4 mm
Quick-release T-piece connector, 4 x 4 mm
Turbine mounting for HOT SPOT
Fuel pump
Auxiliary gas tank
Fuel/Auxiliary gas valve
LED circuit
Ecu electronics
Set of leads
Installation set, complet
Turbine mounting for KANGAROO
Turbine manual, German
Turbine manual, English / French
Airspeed sensor
Propane filler valve
Turbine oil (1 container, approx. 0.95 l)
43
03/2001