Aux Channel Functions - GRAUPNER JetCat P60 Instructions D'utilisation

[Seite 36]

AUX channel functions

The AUX channel (= 3-position switch) can also be switched off ("AUX-Channel Function" parameter in
LIMITS menu).
In this mode it is possible to control the turbine using only one channel (= throttle stick).
The possible options for the "AUX-channel func" parameter are:
Option
NOT USED
ON, TrbCtrl ON
ON, TrbCtrl OFF
Description
AUX channel not in use (-> AUX lead must not be connected to receiver)
Starting the turbine:
1. Trim and throttle stick back (if green LED flashes)
2. Trim forward
3. Stick to idle (min. 1 second)
4. Stick to full-throttle -> start
Shutting the turbine down:
Trim and throttle stick back -> OFF
The "AUTO-OFF" function is not available in this mode of operation.
The post-run cooling process for the turbine is always active, and cannot be disabled.
AUX channel in use (-> AUX lead must be connected to receiver)
This is the default setting.
The turbine is controlled (OFF/RUN/AUTO-OFF) via the AUX switch (3-position
switch).
This setting corresponds to the method of working used by earlier versions of the
software (pre-V2.01P).
AUX channel in use (-> AUX lead must be connected to receiver)
The AUX channel is active, but is only used for the functions of Speed-Control and
controlling the Smoker valve. The turbine is controlled using the throttle channel only.
Starting the turbine:
1. Trim and throttle stick back (if green LED flashes)
2. Trim forward
3. Stick to idle (min. 1 second)
4. Stick to full-throttle -> start
Shutting turbine down:
Trim and throttle stick back -> OFF
The "AUTO-OFF" function is not available in this mode.
The post-run cooling process for the turbine is always active, and cannot be disabled.
34