Switching On The Controller; Controller Protection Functions; Tips And Suggestions For The First Flight; Environmental Informations - GRAUPNER HoTTrigger Competition 1400 S Instructions

Switching on the controller

1. Make sure that the throttle stick is always located on the motor stop position when you plug in the battery
2. Plug the battery to the connector of the controller, the motor plays a melody like "Do Re Mi"
EN
3. After 2 sec. the motor beeps with a long beep (B--), which means that the throttle stick is in the motor stop position for a
safe start
4. After 2 sec., the motor will beep in the tone of the set brake function
5. Now, the controller is ready to operate the motor

Controller protection functions

1. Start-up protection. If the motor within 2 seconds after the accelerator will not begin to rotate, the controller will shut down
to prevent an uncontrolled running. In this case, move the throttle stick to the stop position to reactivate the controller. (This
may be caused by: The connection to the motor is not correct, the propeller is blocked, etc.)
2. Overheat protection: When the temperature exceeds 110 ° C, the motor is limited
3. Motor stop in case of loss of the signal. If the signal is interrupted by the receiver longer than 1 sec, the motor performance
is reduced, longer than 2 seconds, the motor is switched off
4. If after plugging in the battery, the output tones are "Beep, Beep, Beep" (Every "Beep" has an interval of 2 sec.), it means
that the battery is over or under voltage
5. If after plugging in the battery, the output tones are "Beep, Beep, Beep" (Every "Beep" has an interval of 0.25 sec.), it means
that the throttle stick is not in motor stop position

Tips and suggestions for the first flight

• After you have assembled the model according to the instructions, programmed the remote control as specified, all batteries
are charged, the first flight will be possible.
• For the first flight there should be not too much wind.
• The construction of the model is very easy, the flight is very sophisticated.

Environmental informations

•
•
•
14 14
This symbol on the product, user manual or packaging indicates that this product must not be disposed of
with other household waste at the end of its life. It must be handed over to the applicable collection point
for the recycling of electrical and electronic equipment.
The materials are recyclable as marked. By material recycling or other forms of re-usage you are making an
important contribution to environmental protection.
Batteries and accumulators must be removed from the device and disposed of at an appropriate collection
point. Please inquire if necessary from the local authority for the appropriate disposal site.
13400.C_hu_V1 13400.C_hu_V1