Explanation Of Leds; Menu Structure; Selecting A Menu; Changing Values / Parameters In A Menu - GRAUPNER JetCat P60 Instructions D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Explanation of the LEDs
Description
Standby
Ignition
Pump running
OK
Special functions:
If the "Standby" and "OK" LEDs flash simultaneously, the turbine battery needs to be recharged.
[Seite 30]

Menu structure

All adjustment parameters are stored in a series of menus, which can be displayed on the GSU screen and
changed by the operator.
The available menus are:
RUN menu
INFO menu
MIN/MAX menu
STATISTICS menu
RC-Check menu
Limits menu

Selecting a menu

The various menus can either be selected directly by pressing the corresponding buttons on the GSU (-> hot
keys), or by pressing and holding the "Select Menu" button; in this case you press the +/- buttons to select
the menu you wish to see.
Within a menu you can leaf through the various options by pressing the +/- buttons on their own.

Changing values / parameters in a menu

To change a value displayed on the screen, hold the "Change Value / Item" button pressed in, and alter the
value using the +/- buttons.
LED is on
Spin up turbine
Glowplug is ON
Fuel pump running
Turbine in control mode
Turbine thrust can be
controlled by the throttle stick.
LED flashes
Manual mode active
---
Glowplug faulty
(open circuit)
a) If turbine is running:
Permissible exhaust gas
temperature exceeded.
b) If turbine is off:
control system is in
"Slow-down" state.
28

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Jetcat p80Jetcat p120Jetcat p160679867996800 ... Afficher tout

Table des Matières