The Led Board - GRAUPNER JetCat P60 Instructions D'utilisation

Zur ECU Temp ...
To ECU
Temp & RPM
Sensor connection
Zur ECU (Glow-plug) ...
To ECU
(glow-plug /
starter device)
3-core lead
[Seite 16]

The LED board

The LED board acts as "distribution box" for the ECU data bus, and also features three LEDs which provide
information about the current state of the Jet-tronic. Ideally the LED board should be installed in the model
with the outward facing socket (close to the three LEDs) easily accessible, and the LEDs clearly visible. The
outward facing socket is normally used for connection to the GSU (= Ground Support Unit) for servicing and
programming. The LED board also includes a small push-button which is used in the procedure for "learning"
the radio control system; it also serves to activate the "manual mode".
3x Status
LED´s
Tast-Schalter
Fig. 1
Explanation of the LEDs on the LED board
3 x Status LED's
3 x status LEDs
Tast-Schalter
Push-button
Erweiterungsbuchse ...
Expansion socket for
connection to GSU
Verbindungsbuchse ...
Socket for
Jet-tronic ("data bus")
15
Erweiterungsbuchse
zum Anschluß der
GSU
Verbindungsbuchse
zur Jet-tronic
(„Data-Bus")