Connecting Up To The Power Supply - Zhermack Zetaclave B 18 Manuel D'utilisation

MAINTENANCE AND USE MANUAL
Zetaclave B has been designed for operation on a rigid worktop parallel to the floor. Suitable
worktops include service furniture (where the operator is standing) or modelling tables (where work
is done sitting down). All worktops must be checked for stability.
The user must provide a power connection with relative socket near the machine installation point.
The user must also install an adequate electrical circuit breaker upstream from the socket as well as
efficacious overload/indirect contact safety devices.
Connection is effected via the safety plug (16A, in compliance with European standards) at the end of
the power lead: this must be inserted in the mains socket.
When connecting check:
• that mains voltage and frequency are as indicated on the identification plate (incorrect power
supply voltage may damage the machine);
• that the mains supply has a proper, efficient earth connection.
It is forbidden to tamper with the power lead and its plug. When replacing them owing
to damage and/or wear please contact an Authorised Service Centre.
A proper earth connection is compulsory. Should it temporarily be necessary
to use an extension lead the latter must comply with the standards in force in
the country of use.
zetaclave B
EN

CONNECTING UP TO THE POWER SUPPLY

Worktops
6.3.1
6.4
153 of 228