Putting The Machine Into Service; Selecting The Language - Zhermack Zetaclave B 18 Manuel D'utilisation

MAINTENANCE AND USE MANUAL
Fig. 1: Place the unit on the horizontal, on the
worktop (see section 6.3.1).
Connect the plug to the mains: follow the instructions
given in section 6.4.
Caution: proceed with care so that the weight of the equipment does not injure your
hands. To leave at least 10 cm between the autoclave and the wall.
Fig. 2: Keep SELECT pressed (1).
Switch machine on with ON/OFF control (2); Push and
hold SELECT until the language appears.
Fig. 3: Press PUMP to change language (1).
Switch machine off to confirm choice (2).
zetaclave B
EN

PUTTING THE MACHINE INTO SERVICE

SELECTING THE LANGUAGE

6.7
6.8
1
2
ON/OFF
2
Figure
1
2
ON/OFF
3
Figure
157 of 228