6.6.2 Print Head Cleaning - Zhermack Zetaclave B 18 Manuel D'utilisation

6.6.2 Print head cleaning

If printouts are difficult to read, the print head should be cleaned using a moistened soaked in
alcohol: open the printer cover, remove the paper roll and clean the head (see points shown in the
picture). Use compressed air to clear dust from the interior of the printer.
6.6.3 Printouts
How to read and interpret the information provided in the printouts.
Model.
Serial number.
Selected cycle.
Info on the cycle underway: minimum
cycle temperature and pressure
values.
Column showing time: hour, minutes,
seconds.
Current cycle phase.
Operator's signature.
156 of 228
Lead out thermal paper over the roll.
the print head is below the cutter. Cleaning should be
carried out with the machine OFF.
If the cover is not properly closed, or if printer is out of
paper, the relevant indicator icon will flash on the
display.
STAR
RELEASE: 0,02
S/N: STAR1234
DATA: 28:12:04
C/N: 0312
CICLO: BOWIE & DICK
134° 2,06bar 3,30min
START
hh:mm:ss °C bar
12:42:25 015,7 0,013
12:47:50 025,3 -0,801
12:55:41 099,7 0,202
12:58:20 068,4 -0,701
13:01:45 103,5 0,200
13:06:32 068,7 -0,701
STERILIZZAZIONE
13:14:54 135,0 2,207
13:15:53 134,9 2,200
13:16:52 134,6 2,180
13:17:52 134,6 2,179
ASCIUGATURA
13:18:53 134,2 2,171
13:19:51 108,8 0,136
13:20:51 095,9 -0,383
13:21:50 090,4 -0,126
FINE CICLO: OK
OPERATORE:
MAINTENANCE AND USE MANUAL
EN
Incremental number of cycles
Column showing temperature values
in degrees centigrade (°C).
Column showing pressure values.
Software release.
Cycle start date.
started.
Cycle result.
zetaclave B