Changing The Printer Roll - Zhermack Zetaclave B 18 Manuel D'utilisation

MAINTENANCE AND USE MANUAL
Demineralizer filters must be changed every 3 - 6 months.
To discharge the dirty water with use of the demineralizer ("B"), the tap must always
be left open.
NEVER connect "A" to "B" on the same terminal: always use two separate hoses.
If the automatic water filling system ("D") is used, it is COMPULSORY to connect the
condensate drainage pipe ("A") to a sewer line and not to the condensate container.
On starting any cycle, the autoclave starts printing all values concerning the selected cycle, plus
the machine model and serial number (paragraph 6.6.3). When the autoclave cycle is completed,
the printer stops printing: cut off the printout by using the built-in cutter (simply pull the paper
upward).
If the cover is not properly closed, or if the printer is out of paper, the relevant indicator icon will
be displayed to warn the user (paragraph 3.3.3).
Refer to the instructions provided by the local health authority for printout-filing.
For a correct and long-lasting storage of the paper printouts, it is necessary to
keep them away from light and heat sources.
To change the printer roll: open the cover, insert a new thermal paper roll (maximum width
should be 57 mm) in the space provided and lead out the paper over the cover roll while closing
the cover. Use only thermal paper. Make sure the thermal paper is correctly
oriented: if the paper is inserted the wrong way up, the printouts will be blank.
zetaclave B
EN
PRINTER

Changing the printer roll

6.6
6.6.1
155 of 228