Connecting Up To The Power Supply - Zhermack SAND S23 Mode D'emploi

MAINTENANCE AND USE MANUAL
The sandblasting equipment (the example
in the figure is the SAND S25R) has been
designed for use on a rigid worktop parallel
to the floor.
Suitable worktops include service furniture
(where the operator is standing) or
modelling tables (where work is done
sitting down). All worktops must be
checked for stability.
The user must provide a power connection with relative socket near the equipment installation point.
The user must also install an adequate electrical circuit breaker upstream from the socket as well as
efficacious overload/indirect contact safety devices.
Connection is effected via the safety plug (16A, in compliance with European standards) at the end of
the power lead: this must be inserted in the mains socket.
When connecting check:
• that mains voltage and frequency are as indicated on the identification plate (incorrect power
supply voltage may damage the equipment).
• that the mains supply has a proper, efficient earth connection.
It is forbidden to tamper with the power lead and its plug. When replacing them
owing to damage and/or wear please contact an Authorised Service Centre.
A proper earth connection is compulsory. Should it temporarily be necessary
to use an extension lead the latter must comply with the standards in force in
the country of use.
SAND S 23 / S 24 / S 24 R / S 25 / S 25 R
EN

CONNECTING UP TO THE POWER SUPPLY

Worktops
6.3.1
6.4
123 of 176