General Operation; Remote Commands - MINN KOTA RIPTIDE SP Manuel De L'utilisateur

GENERAL OPERATION

USING THE HAND REMOTE WITH THE CORDED FOOT PEDAL
• When the corded foot pedal's MOM-CON switch is in the CON position or when the Momentary On switch is held, the receiver
WILL NOT R POND to any remote commands. When remote commands are received, the receiver will emit an audio chirp.
This will indicate that the remote is functioning properly although a corded foot pedal switch is active and is overriding the
remote.
• When the MOM-CON switch is in the MOM position, the angler may begin using the remote at any time.
• As soon as any remote button is pressed, the initial speed setting will be approximately the same as the corded foot pedal's
speed control position. However, the prop will not automatically turn on until the remote's prop on/off button is pressed.
• Pressing the corded foot pedal momentary switch or steering switches will override the remote and receiver function and con-
trol will automatically go to the corded foot pedal. The prop speed will also revert to the current position of the speed control
on the corded foot pedal.
USING THE COPILOT WITHOUT THE CORDED FOOT PEDAL
• If the foot pedal is not being used, the CoPilot receiver will always react to any commands from the CoPilot remote.

REMOTE COMMANDS

There are fi ve buttons on your CoPilot:
• PROP ON/OFF
Turns the propeller on or off . Press the button once to turn the propeller ON;
press button a second time to turn it OFF. The button does not need to be held down.
EER LE EER RIGHT
• /
Causes the motor to turn in the desired direction as long as the button is held down. If a steering button is held for more than
seven seconds, the steering will automatically stop until the button is pressed again.
• INCRE E SPEED/DECRE
Pressing and releasing these buttons causes the speed to increase or decrease by one level. The speed is adjustable from level
0-10. At level 0, the prop will not turn.
- In audio mode 2, an audible beep is heard for each step change in speed. Attempting to go higher than speed 10 or lower
than speed 0 will result in the speed not changing and no beep will be heard. See the Audio Mode section for more informa-
tion.
- If the receiver senses no foot pedal or remote operation for 1 hour, the remote speed setting is automatically set to zero.
This helps prevent unintentional activation of the propeller if the PROP ON/OFF remote button is inadvertently pressed.
* For CoPilot equipped motors only.
©2015 Johnson Outdoors Marine Electronics, Inc. ©2015 Johnson Outdoors Marine Electronics, Inc.
USING THE COPILOT* USING THE COPILOT
E SPEED
Decrease Speed
Steer Left
minnkotamotors.com | 13 minnkotamotors.com | 7
Increase Speed
Prop ON/OFF
Steer Right