Parking Brake Adjustment - Yamaha VK10L Mode D'emploi

PARKING BRAKE ADJUSTMENT/

TRACK TENSION ADJUSTMENT
3. Measure:
• Brake pad clearance (b + c)
4. Adjust:
• Brake pad clearance
Adjustment steps:
• Loosen the locknut 1.
• Turn the adjuster 2 in or out until the specified
clearance between the brake pad 3 and brake
disc 4 is obtained.
• Tighten the locknut.
TRACK TENSION ADJUSTMENT
A broken track or track fittings, and debris
thrown by the track could be dangerous to an
operator or by standers. Observe the following
precautions.
• Do not allow anyone to stand behind the
machine when the engine is running.
• When the rear of the machine is raised to
allow the track to spin, a suitable stand must
be used to support the rear of the machine.
Never allow anyone to hold the rear of the
machine off the ground to allow the track to
spin. Never allow anyone near a rotating
track.
• Inspect the condition of the track frequently.
Replace the track if it is damaged to a level
where the fabric reinforcement material is vis-
ible.
1. Lift the rear of the machine onto a suitable stand
to raise the track off the ground.
14
INSP
Out of specification → Adjust.
Parking brake pad clearance:
1.5 ~ 2.0 mm (0.059 ~ 0.079 in)
WARNING
ADJ