Table des Matières
Publicité
STEERING
9. Install:
• Handlebar
CAUTION:
• Be sure the projection on the handlebar is not
installed into the area a shown.
• Be sure the side of the holder with the small
gap b faces forward.
• First tighten the bolts on the front side of the
handlebar holder, and then tighten the bolts
on the rear side.
• Center the match mark c on the handlebar 1
between the lower handlebar holder 2.
Handlebar holder bolt:
15 Nm (1.5 m · kg, 11 ft · lb)
10. Check:
• Ski toe-out
Refer to "STEERING SYSTEM" in CHAPTER
2.
56
CHAS
Publicité
Table des Matières
