Table des Matières
Publicité
REAR SUSPENSION
Shock absorber nut:
49 Nm (4.9 m · kg, 35 ft · lb)
CAUTION:
Never allow the adjusting bolt to move while
tightening the nut.
• This model has a "Easy adjust" system for the
Full rate adjuster. The bolt has teeth on it. So
when the bolt is turned, it rides up and down the
bracket.
NOTE:
• The nut has to be loosen first, while the bolt is
held in place with a wrench.
• Then the bolt can be turned to adjust the shock
position up or down.
• If the bolt is turned with the nut tight, it is possible
to strip the teeth off the bolt.
47
INSP
ADJ
Publicité
Table des Matières
