Publicité
3
Features and Functions
– Remote Interface Operation:
Waveform Polarity
In the normal mode (default), the waveform goes positive during the first part of
the cycle. In the inverted mode, the waveform goes negative during the first part
of the cycle.
– As shown in the examples below, the waveform is inverted relative to the offset
– When a waveform is inverted, the Sync signal associated with the waveform is
– Front-Panel Operation: Press
– Remote Interface Operation:
82
OUTPut {OFF|ON}
The APPLy command overrides the current setting and automatically enables
the Output connector.
voltage. Any offset voltage present will remain unchanged when the waveform
is inverted.
Normal
No Offset Vol tage
not inverted.
press the Normal softkey again to toggle between the "Normal" and "Invert"
selections.
OUTPut:POLarity {NORMal|INVerted}
Inverted
Normal
0V
With Offset Vol tage
and select the Output Setup softkey. Then
Inverted
Offset
0V
Keysight 33210A User's Guide
Publicité
