Publicité
Trigger Out Signal
A "trigger out" signal is provided on the rear-panel Trig Out connector (used with
sweep and burst only). When enabled, a TTL-compatible square waveform with
either a rising edge (default) or falling edge is output from the Trig Out connector at
the beginning of the sweep.
– When the Internal (immediate) trigger source is selected, the function
– When the External trigger source is selected, the function generator
– When the Manual trigger source is selected, the function generator outputs a
– Front-Panel Operation: After enabling sweeps, press the Trigger Setup
– Remote Interface Operation:
Keysight 33210A User's Guide
generator outputs a square waveform with a 50% duty cycle from the Trig Out
connector at the beginning of the sweep. The frequency of the waveform is
equal to the specified sweep time.
automatically disables the "trigger out" signal. The Trig Out connector cannot
be used for both operations at the same time (an externally-triggered
waveform uses the same connector to trigger the sweep).
pulse (>1 µs pulse width) from the Trig Out connector at the beginning of each
sweep or burst.
softkey. Then select the desired edge by pressing the Trig Out softkey.
OUTPut:TRIGger:SLOPe {POSitive|NEGative}
OUTPut:TRIGger {OFF|ON}
Features and Functions
3
113
Publicité
