Publicité
3
Features and Functions
GPIB Configuration
Each device on the GPIB (IEEE-488) interface must have a unique address. You can
set the function generator's address to any value between 0 and 30. The address
is set to "10" when the function generator is shipped from the factory. The GPIB
address is displayed at power-on.
– The address is stored in non-volatile memory and does not change when
– Your computer's GPIB interface card has its own address. Be sure to avoid
– Front-Panel Operation: Press
– Remote Interface Operation:
LAN Configuration
The following sections describe the primary LAN configuration functions that you
can set from the 33210A front-panel Utility menu. SCPI commands are listed
where applicable. In addition, there are some LAN configuration functions that
can be performed only by using the SCPI commands. For a complete listing of the
LAN configuration commands, refer to
Commands" starting on page 263.
If you change any LAN settings, you must cycle the power to activate the new
NOTE
settings. This is true for all LAN settings, including turning DHCP and Auto IP on
or off.
146
power has been off or after a remote interface reset.
using the computer's address for any instrument on the interface bus.
Address field appears. Use the knob and cursor keys, or the numeric keypad,
to change the address.
SYSTem:COMMunicate:GPIB:ADDRess <address>
SYSTem:COMMunicate:GPIB:ADDRess?
and then select the I/O softkey. The GPIB
Chapter
4,
"Interface Configuration
Keysight 33210A User's Guide
Publicité
