Publicité
3
Features and Functions
Trigger Out Signal
A "trigger out" signal is provided on the rear-panel Trig Out connector (used with
sweep only). When enabled, a TTL-compatible pulse waveform with either a rising
edge (default) or falling edge is output from the Trig Out connector at the beginning
of the burst.
– When the Internal (immediate) trigger source is selected the function
– When the Manual trigger source is selected, the function generator outputs a
– When the External trigger source is selected, the function generator
– Front-Panel Operation: After enabling bursts, press the Trigger Setup softkey.
– Remote Interface Operation:
122
generator outputs a square waveform with a 50% duty cycle from the Trig Out
connector at the beginning of the burst. The frequency of the waveform is
equal to the specified burst period.
pulse (>1 µs pulse width) from the Trig Out connector at the beginning of each
burst.
automatically disables the "trigger out" signal. The Trig Out connector cannot
be used for both operations at the same time (an externally-triggered
waveform uses the same connector to trigger the burst).
Then select the desired edge by pressing the Trig Out softkey.
OUTPut:TRIGger:SLOPe {POSitive|NEGative}
OUTPut:TRIGger {OFF|ON}
Keysight 33210A User's Guide
Publicité
