Publicité
1
Quick Start
To Set the Output Amplitude
At power-on, the function generator outputs a sine wave with an amplitude of 100
mV peak-to-peak (into a 50Ω termination). The following steps show you how to
change the amplitude to 50 mVrms.
1 Press the "Ampl" softkey.
2 Enter the magnitude of the desired amplitude.
3 Select the desired units.
30
The displayed amplitude is either the power-on value or the amplitude
previously selected. When you change functions, the same amplitude is used if
the present value is valid for the new function. To set the amplitude using a high
level and low level, press the Ampl softkey again to toggle to the HiLevel and
LoLevel softkeys (the current selection is highlighted).
Using the numeric keypad, enter the value "50".
Press the softkey that corresponds to the desired units. When you select the
units, the function generator outputs the waveform with the displayed
amplitude (if the output is enabled). For this example, press mV
.
RMS
Keysight 33210A User's Guide
Publicité
