Publicité
Remote Interface Configuration
This section gives information on configuring the function generator for remote
interface communication. For information on configuring the instrument from the
front panel, see
information on the SCPI commands available to program the function generator
over the remote interface, see
on page 163.
The Keysight 33210A supports remote interface communication using a choice of
three interfaces: GPIB, USB, and LAN. All three interfaces are "live" at power up.
This section describes some interface configuration parameters that you may
need to set on your function generator.
– GPIB Interface. You need only set the GPIB address for the function generator
– USB Interface. There is nothing to configure on your function generator. Just
– LAN Interface. By default, DHCP is On, which may enable network
Connectivity Software and Product CDs
The Keysight 33210A is shipped with two CDs:
– Keysight Automation-Ready CD: This CD contains the Keysight IO Libraries
– Keysight 33210A Prod uct-Reference CD: This CD contains the 33210A
Keysight 33210A User's Guide
"To Configure the Remote Interface"
and connect it to your PC using a GPIB cable.
connect the function generator to the PC with a USB cable.
communication over the LAN interface. You may need to set several
configuration parameters as described in the LAN configuration sections that
follow.
Suite software, which must be installed to enable remote-interface operations.
The CD auto-starts and provides information on installing the software. Refer
to the Keysight Technologies USB/LAN/GPIB Connectivity Guide, which is
provided on this CD-ROM, for additional background information.
instrument drivers, the Keysight Intuilink Waveform Editor software, the
complete set of Keysight 33210A product manuals, and programming
examples. The CD auto-starts and provides a Welcome page with instructions.
Chapter 4, "Remote Interface
Features and Functions
starting on page 61. For
Reference", starting
3
145
Publicité
