Publicité
4
Remote Interface Reference
PWM:STATe {OFF|ON}
PWM:STATe?
Disable or enable PWM. To avoid multiple waveform changes, you can enable
PWM after you have set up the other modulation parameters. The default is OFF.
The :STAT? query returns "0" (OFF) or "1" (ON).
– The function generator will allow only one modulation mode to be enabled at a
– The function generator will not allow PWM to be enabled at the same time
– PWM is allowed only when pulse is the selected function.
222
time. For example, you cannot enable PWM and AM at the same time. When
you enable PWM, the previous modulation mode is turned off.
that sweep or burst is enabled. When you enable PWM, the sweep or burst
mode is turned off.
Keysight 33210A User's Guide
Publicité
