Publicité
To configure the hob into Power management
1. Touch ON/OFF key to switch on the power supply. The buzzer beeps once, all displays show "– "and "– – ".
2. Touch front left zone key and rear left zone key simultaneously for 3 seconds. The buzzer beeps
indicating that the induction hob enters selection of ECO Mode. (Display shows the preset power 7.0kW)
3. Touch timer key, then timer display will flash. You can select the power setting now.
4. To change the total power setting, press the front left area key to select a new total power setting.
Pressing the front left area key again will cycle through the options. The timer display will show four options:
25, 35, 45, and 70. For example, when the timer display shows the number "25," it indicates that the total
power is set to 2500W. Keep pressing the front left area key until you find the desired power setting.
* By default, the power setting is factory set to 7.0kW.
5. Touch timer key again, the timer display stop flashing and the previously selected zone key will show "o"
indicating that the setting is confirmed.
6. Touch the ON/OFF to switch off. Then switch on and the hob is configured ready to use at the ECO Mode
you set for.
7. Touch the ON/OFF to switch on, now you can use the new power setting.
70
70
25
25
19
Publicité
