Publicité
If the electrical appliance is not supplied with a power cable, use one with a
●
minimum conductor diameter of 2.5 mm2 for power up to 7200 Watt; for higher
power levels, the diameter must be 4 mm2.
The temperature must not reach 50°C above room temperature anywhere along
●
the cable.
The appliance is intended for permanent connection to the power supply.
●
Please note! Before reconnecting the circuit to the mains power supply, make
●
sure that it is working correctly, always check that the power cable is correctly
installed.
Please note! The interconnection cable must be replaced by the authorized
●
technical support service or by a person with similar qualifications.
Note : the product is equipped with a Power Limitator function, which allows a
maximum power limit to be set The limit must be set at the time of the product's
connection to the electrical network or when the electrical network itself is
reconnected (within the following 2 minutes).
3.3 Mounting
Before starting the installation:
● After unpacking the product, check that it has not been damaged during
transport and in the event of problem, please contact the reseller or the Customer
support service before installing it.
● Check that the product is the right size for the installation area.
● Check for accessories (e.g. bags containing screws, warranty certificates, etc.)
inside the packaging (placed there for transport reasons). Remove and keep them
safe, if present.
● Also check that there is a power socket near the installation area.
Preparing the cabinet for installation:
- The product cannot be installed above cooling appliances, dishwashers,
heaters,ovens, washing machines and dryers.
- Create the cut-outs in the cabinet before inserting the hob and carefully remove
any shavings or sawdust.
- to optimist the filter installation, it is advisable to cut a slot in the plinth to insert
a grille (available on the market) IMPORTANT:
sealant (S), which withstands temperatures up to 250°; before installation,
thoroughly clean the surfaces to stick and eliminate any substance that may
compromise adhesion, (e.g. release agents, preservatives, fats, oil, dust, traces
of old adhesives, etc.); the adhesive should be uniformly spread all around the
outside of the frame; after sticking, leave the adhesive to dry for about 24 hours.
Caution! Failure to install screws and fasteners in accordance with these instructions
may result in electrical hazards.
Note: to ensure the correct installation of the product, it is recommended to tape
the pipes using an adhesive with the following characteristics:
- soft elastic PVC film, with an acrylic-based adhesive.
- compliant with DIN EN 60454 regulations.
- flame retardant.
use a single-component adhesive
17
Publicité
