Publicité
Les langues disponibles
Les langues disponibles
-
Keep children, frail persons, observers or animals at a safe distance and out of the product's range before
operating it in order to avoid damage, danger or injury.
-
Keep the tool away from sources of heat, oil, solvents, and any environmental conditions other than those
indicated in the manual and permitted.
-
Attention is drawn to the fact that in the event of damage or other condition with leakage of battery fluid, there
may be risks to personnel in the event of contact or other situation resulting from such leakage. Do not touch
any liquid from the battery pack. In case of contact, rinse immediately with clean water. If the liquid comes into
contact with your eyes, rinse thoroughly with clean water and immediately seek medical attention.
-
Use the product only for the purposes described. Any other use may cause injuries.
-
Handle and use the product by gripping it completely and firmly with both hands to avoid misuse, injuries,
falls and accidental impacts.
-
Always check that the safety devices are working properly.
-
Before starting the product, make sure that there are no foreign bodies between the moving parts.
-
Follow the manufacturer's instructions for adjustments and lubrication (see chap. 7).
-
Never use the product if it is damaged, wrongly regulated or only partially assembled.
CAUTION
Please refer to the documentation (manual, data sheet or pictograms) supplied with the Lithium battery for
all indications and warnings to be observed and concerning the use of the battery.
6.2 OPERATION
This paragraph sets out the conditions to be met in order to start the product.
6.2.1 PRODUCT START-UP
Once assembled as described in paragraph 5.2, proceed with start-up:
•
Switch the tool on by pressing the ON-OFF switch (2) to the ON position.
If the power unit is powered by a plug-in battery, the battery charge status can be displayed by pressing button (4).
CAUTION!
The moment the ON-OFF switch (2) is pressed in the ON position, the tool starts working immediately.
Be sure to position the tool away from people or property. Failure to comply with the warning is
potentially dangerous for operator safety.
0310.0436_00
95
Publicité
