CAMPAGNOLA POWER ECO PLUG-IN Manuel D'utilisation Et D'entretien page 77

The CE marking is placed on the product as shown in the following figure.
Below is a facsimile of the Declaration of Conformity supplied with the product:
(*) A detailed list of the directives and standards applied can be found in the declaration of conformity supplied with
the product.
4.5 LIMITS OF USE
The product is intended for the use and operation described in chapter 3 of this manual.
The use of unsuitable material or not within the working range of the product can cause serious damage and impair
its proper functioning.
4.6 DANGER ZONES
The product in question is intended for use by qualified personnel duly instructed in its use, who are familiar with
the situations/problems relating to the use of products with harvesting heads in the agricultural and professional
sector and who are aware of the characteristics and risks present in the working environment.
The product in question is characterised by assemblies and parts that are considered hazardous. All areas
considered dangerous with the exception of the shaking areas were duly protected.
In order to limit risks in danger zones, appropriate prevention and protection measures were taken. Observe the
instructions, both procedural and relating to 'Personal Protective Equipment', given in this manual.
4.7 ENVIRONMENTAL OPERATING CONDITIONS
The environment in which the product is used is an outdoor environment protected against aggressive agents
such as corrosive vapours or sources of excessive heat.
Unless otherwise specified, the product is intended for use under the following environmental conditions:
➢ Below 1000m above sea level.
➢ Ambient temperature between 5°C and + 45°C. (24-hour average ≤ 35°C)
➢ Relative humidity 30% to 85% without condensation.
➢ Material temperature, where applicable < 45° C.
0310.0436_00 77