CAMPAGNOLA POWER ECO PLUG-IN Manuel D'utilisation Et D'entretien page 93

The Icarus harvesting head is supplied with the teeth removed. Follow the procedure below to assemble them.
•
Remove the Icarus harvesting head and the eight teeth (20) from the packaging.
•
Insert the teeth with light pressure on the two supports (21), taking care that the reference planes are
correctly positioned and making sure that the locking teeth have come out of the support.
5.4 CHECKS AND TESTS BEFORE START-UP
This paragraph sets out the checks and controls that must be carried out on the product before initial start-up.
•
Check that the handle and harvesting head are properly tightened on the extension pole.
•
Check that on the extension pole clamp, the lever (31) is in the locked position.
CAUTION
Before starting the product, carry out an integrity check of all its parts, including the battery.
Before use (see par. 6), make sure, in addition to the suitability of the battery for the specific product purchased,
that the battery is fully inserted and locked, in order to avoid falls and/or damage to property or persons.
5.5 DECOMMISSIONING
The following paragraph contains some tips and indications for the decommissioning, dismantling and removal of
the product at the end of its service life.
The following steps, as well as the instructions in the manuals of the components used, must be taken into
account when decommissioning.
The materials of which the product is made are essentially:
1) Painted, plastic-coated or galvanised ferritic steel;
2) Polyethylene plastic material;
3) Elastomers, PTFE, graphite;
4) Gear oil;
5) Motor;
6) Electrical cables with associated conduits;
7) Electronic control and actuation devices;
8) Pneumatic hoses and fittings. (only for pneumatic tools)
0310.0436_00
ICARUS
93